Prestigio RoadRunner 330 - 6. Playback Options; Playback on Device (DVR); Playback on Computer (PC)

device turns on and starts video recording automatically if shaking or stroke is detected.
3
User Manual RoadRunner 330
3. Sengs
Before recording, you can set up the device according to your requirements.
-In video/picture preview mode, press [MENU] to enter video/picture
sengs, press it again go the general sengs, press it third me to exit.
-In seng list, use
[ ]/[ ] to navigate the menu, press [OK] to get the
opons and confirm the selecon, press [MENU] to exit.
Video sengs
General sengs
3
Ÿ Resoluon: Select the resoluon of recorded video: 1920x1080P, 1280x720P, 640x480P
Ÿ Loop Recording: Set the video duraon (1, 3, 5, 10 minutes or off) for loop recording. When the
microSD card is full, the device will delete the oldest unlocked video file automacally.
Ÿ Exposure: Set exposure value to determine how much light the camera’s sensor receives. For lowlight
situaons, use a higher exposure.
Ÿ Moon detecon: Turn on or off moon detecon. If there is any moon detected while the car
engine is stopped, your car DVR will start recording automacally.
Ÿ Date stamp: Add date and me stamp onto videos.
Ÿ Record audio: on/off
Ÿ G-sensor Sensivity: Select the sensivity of the G-sensor. The smaller the number is, the higher the
sensivity is. When reaching the sensive value (such as collision), the recording file will be
automacally protected.
Picture sengs
Ÿ Long press of MENU buon takes to Picture Mode
Ÿ Capture Mode: set the mer single/2s/5s/10s
Ÿ Resoluon: Select the picture image size from 12M, 10M, 8M, 5M, 4M, 3M, 2M, 1.3M
Ÿ Sequence: Turn off/on photo sequence
Ÿ Quality: Set the photo quality Fine/Normal/Economy
Ÿ Sharpness: Adjust the sharpness.
Ÿ White Balance: Select an appropriate white balance, so images have a true-to-life color range. It is for
specific lighng situaons.
Ÿ Color: Set the photo color Standard/Black&White/Sepia
Ÿ ISO: Set the ISO Auto/100/200/400
Ÿ Date/Time: Set date and me on device.
Ÿ Auto Power Off: Set automac power off when the device is not in use.
Ÿ Beep Sound: Turn off/on beep sound
Ÿ Language: Choose your language.
Ÿ Frequency: For a given luminance, the frequency of light fluctuaon that evokes a sensaon of flicker.
Set a right flickering frequency to avoid horizontal stripe interference.
Ÿ Format: Format the memory card.
Ÿ Default Sengs: Restore to default sengs.
Ÿ Screen Savers: Adjust the screen saver me off/1min/3min/5min
Ÿ Lamp Sengs: Turn off/on the flash light
Ÿ Parking Monitor: Turn off/on parking monitor.
Ÿ Version: Display the current system version.
Formang will erase all your stored data. Back up your data before proceeding.
In Parking Mode G-sensor is ON. While power off,
After recording (ÿ30 sec) is finished, the device will turn off until the next event.