3
3.
Settings
Before recording, you can set up the device according to your requirements.
- In video/picture preview mode, press [MENU] to enter video/picture
settings, press [Set up] go the general settings, press [MENU] two time
to exit.
- In setting list, use [ ]/[ ] to navigate the menu, press [OK] to get the
options and confirm the selection, press [MENU] to exit.
Video Settings
Size: Select the resolution to record video 1080p30, 720p30.
Time Stamp: Add date and time stamp into video.
Loop Recording: Set the video duration (1, 3, 5 minutes or off) for loop recording. When the
microSD card is full, the device will delete the oldest unlocked video file automatically.
Audio Record: on/off.
EV: Exposure compensation. Select from EV- 2.0, EV- 5/3, EV- 4/3, EV- 1.0, EV- 2/3, EV- 1/3,
EV0.0, EV+1/3, EV+2/3, EV+1.0, EV+4/3, EV+5/3, EV+2.0.
Motion Detection: Turn on or off motion detection. If there is any motion detected while the car
engine is stopped, your car DVR will start recording automatically.
Setup: Press setup to enter to General Settings.
Picture Settings
Press mode button to enter Picture Settings.
Size: Select the picture image size from 3MP, 5MP.
Time Stamp: Select the time stamp format: off, Date only, Date&time.
Loop Settings: Select the time length between photo shootings: Single, 1MIin, 3Min, 5Min.
Setup: Press setup to enter to General Settings.
General Settings
Format: Format the memory card.
Formatting will erase all your stored data. Back up your data before proceeding.
Language: Choose your language.
Beep: Switch on/off key tone.
Auto Off: Set automatic power off when the device is not in use: 5min, 3min, 1min or off.
Screen Off: Set screen saver time: 5min, 3min, 1min or off.
Power Delay: Set delay power off time: 10sec, 20sec, 30sec or off
G-sensor: Select the sensitivity of the G-sensor.
Light Frequency: For a given luminance, the frequency of light fluctuation that evokes a sensation
of flicker. Set a right flickering frequency to avoid horizontal stripe interference.
Date Format: Select date format.
Date Input: Set date on device.
Time Input: Set time on device.
System Reset: Reset the system to the factory setting.
FW Version:
Display the current system version.
To Next Page
Loading...
