34
www.pridemobility.com Colt
VII. DISASSEMBLY AND ASSEMBLY
DISASSEMBLY
You can disassemble the scooter into several pieces:
the seat, the front section, the rear section, the bat-
tery shroud, the basket and the batteries. See figure
18. No tools are required to disassemble or assemble
your scooter, but keep in mind that the disassembled
sections of the scooter take up more floor space than
the assembled unit. Always disassemble or assemble
your scooter on a level, dry surface with sufficient
room for you to work and move around your scooter-
about 1.5 metres (5 feet) in all directions. Remember
that some scooter components are heavy and you
may need assistance when lifting them.
WARNING! Do not lift beyond your
physical capability. Ask for
assistance when necessary while
disassembling or assembling your
scooter.
1. Remove the seat by lifting it straight up and off of
the scooter. If you encounter resistance when re-
moving the seat, disengage the seat rotation lever
and swivel the seat back and forth while lifting up
on the seat.
2. Gently pull the battery shroud up and off of the
scooter.
3. Disconnect the battery tie-down strap.
4. Unplug both battery harnesses by pulling each har-
ness straight up. See figure 19.
5. Remove the batteries from the battery wells.
WARNING! Failure to unplug both
battery harnesses prior to
separating the front and rear
sections could result in permanent
damage to the scooter.
Figure 18. Scooter Components
Figure 19. Harness Connections
FRONT SECTION
SEAT
REAR SECTION
BATTERY SHROUD
BATTERIES
BASKET
BATTERY HARNESS CONNECTIONS
BATTERY TIE-DOWN STRAP
To Next Page
Loading...
