Pride Mobility Jazzy EVO 613 - Page 14

14 www.pridemobility.com Jazzy EVO Series
V. COMFORT ADJUSTMENTS
NOTE: The most common conguration of the
seat adjustment hardware is shown in gure 9.
Your product may be equipped with a dierent
conguration. All congurations operate in a
similar manner.
Manual Recline Seatback Adjustment
If your power chair is equipped with a manual recline
seatback, you can adjust the seatback angle with the
seatback release lever. The lever is located on the
right side of the seat base. See gure 1.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with a limited-recline
seatback, you can adjust the seatback up to a 115°
angle.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat
hinge. See gure 9.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge
and tighten.
1
3
2
4
5
7
6
Figure 9. Armrest and Seatback Adjustments
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
To change the armrest width:
1. Locate the adjustment hardware on each side of the armrest receiver bracket. See gure 9.
2. Loosen the adjustment hardware.
3. Slide the armrests in or out to the desired width.
4. Tighten the adjustment hardware.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the oor.
2. Loosen the jam nut. See gure 9.
3. Turn the adjusting screw to raise or lower the front of the armrest.
4. Tighten the jam nut to lock the adjusting screw into place.
1. Jam Nut
2. Armrest Angle Adjusting Screw
3. Armrest Height Adjusting Setscrews
4. Seatback Angle Adjusting Screw
5. Armrest Knob
6. Setscrew
7. Controller Bracket Receiver
Identification Key