30
www.pridemobility.com Ultimate-4 XL
VII. COMFORT ADJUSTMENTS
POWER SEAT (OPTIONAL)
Your scooter may be equipped with a power seat. The power seat actuator is designed to raise or lower the seat
automatically with minimal effort on the part of the operator. The power seat switch is located on the tiller console.
Operating your power seat:
1. Release the throttle control lever.
2. Ensure your scooter is level and stationary.
3. Set the speed adjustment dial to the slowest setting
4. Toggle the power seat switch located on the tiller console to the on position.
5. To raise the power seat, operate your throttle control lever in the forward direction.
6. Release the throttle control lever when you have attained your desired height.
7. To lower the power seat, operate your throttle control lever in the reverse direction.
8. Ensure your seat is in the lowest position and that you have fully released the throttle control lever.
9. Toggle off the power seat switch before you attempt to drive your scooter again.
WARNING! The power seat is intended for operation only while your scooter is stationary
and on a level surface. Its purpose is to aid you in reaching objects.
Strict adherence to the following safety rules is vital to your safety:
n Operate the power seat only on level ground.
n Do not attempt to operate the power seat switch with the throttle control
lever depressed.
n Do not attempt to raise or lower the seat while in motion!
n Do not drive your scooter unless the power seat is fully retracted (in lowest position).
n It is recommended that the scooter be driven only with the seat in the
lowest position.
Failure to comply with the above instructions, warnings and safety rules for power seat
use could result in serious personal injury and damage to your mobility device.
To Next Page
Loading...
Need help?
General
