Basic Operation Instructions 7
www.pridemobility.com GC2 Controller
GC2 CONTROLLER
The GC2 controller is a fully-programmable, modular electronic controller
system that allows you to operate your power chair. It is designed to allow
the user to have complete control over chair movement and speed.
The controller has been pre-programmed to meet a typical user’s needs. The
program is set using either a personal computer with software provided by
the controller manufacturer or with a hand-held programmer, also provided
by the controller manufacturer.
WARNING! The controller program can affect speed,
acceleration, deceleration, dynamic stability, and braking.
If it is programmed incorrectly or outside of the safe limits
as determined by your healthcare professional, it can
create a dangerous situation. Only the power chair
manufacturer, an authorized representative of the
manufacturer, or a trained service technician should
program the controller.
PRECAUTIONARY GUIDELINES
Before operating the GC2 controller, please read the following. These
guidelines are provided for your benefit and will aid you in the safe opera-
tion of the control system.
Turn off the power to the controller when transferring to or from your
power chair.
Follow all of the procedures and heed the warnings as explained in your
power chair owner’s manual.
To Next Page
Loading...
Need help?
General