Victory 9/10 Technical Troubleshooting Guide www.pridemobility.com 11
H.< J$(#! (#0! X0+! %($33! $1%0*(08! 218! (4*108! ()! (#0! DF! :)%$($)1P
41:346!')110'()*!\2!;*)O!')110'()*!`2<!See diagram 3<
HH< N02%4*0!*0%$%(21'0!;*)O!:$1!Z!()!:$1!\!)1!')110'()*!\2<!See
figure 22<
!If your multimeter indicates an open, (#01! *0:32'0! (#0
')1(*)330*!$1(0*;2'0!#2*10%%!R\S!218!*0(0%(!(#0!%+%(0O<
!If your multimeter indicates less than 1 ohm, (#01!*0:32'0!(#0
')1(*)330*!R`S!218!*0(0%(!(#0!%+%(0O<
Figure 22. Connector 7a
SECTION 3 - BEEP CODE DIAGNOSIS
"#0!')1(*)330*!R`S!:0*;)*O%!:0*$)8$'!8$261)%($'%!)1!(#0!030'(*)1$'%!);!(#0!&$'()*+!,!)*!./!%'))(0*<!"#0!')1(*)330*!R`S
O)1$()*%!')O:)101(%!);!(#0!030'(*$'23!%+%(0O!%4'#!2%!52((0*+!'#2*60P!030'(*)O2610($'!5*2X0!*0%$%(21'0P!(#*)((30!:)(!R.ZS
):0*2($)1P! 218! %:008! :)(! R.\S! ):0*2($)1<! J#01! (#0!')1(*)330*!R`S! %01%0%! (#2(! 21+!)10!);!(#0%0!')O:)101(%!$%!)4(!);
*2160P!$(!%)418%!2!%0*$0%!);!500:%<!"#0!%'))(0*!B$33!1)(!8*$90!41($3!(#0!;243(!$%!*0%)3908<
NOTE: The beep code will begin with a series of rapid beeps, followed by a number of slower beeps. The slower
beeps comprise the actual beep code. The beep code will be generated only once. To repeat the beep code, remove
and reinsert the key.
Beep Code #3 - High Battery Voltage
Symptoms:
"#0!')1(*)330*!R`S!500:%!(#*00!($O0%<
Diagnosis:
"#0!52((0*$0%!#290!50')O0!)90*'#2*608<
Solution:
U%0!(#0!;)33)B$16!:*)'084*0!()!'302*!(#0!500:!')80=
.< G)B0*!4:!(#0!%'))(0*!218!B2$(!;)*!(#0!52((0*+!9)3(260!()!8*):<!
NOTE: Do not allow the battery condition meter to drop down into the red!
NOTE: The Victory 9 or 10 scooter should only be charged with the off-board charger supplied with the unit!
Beep Code #5 - Brake Fault
Symptoms:
"#0!')1(*)330*!R`S!500:%!;$90!($O0%<
Diagnosis:
"#0!%'))(0*!O2+!50!$1!;*00B#003!O)80<
"#0*0!O2+!50!2!%#)*(!$1!(#0!5*2X0<
Solution:
U%0!(#0!;)33)B$16!:*)'084*0!()!'302*!(#0!500:!')80=
.< N2X0!%4*0!(#0!%'))(0*!$%!$1!8*$90!O)80<!G433!(#0!O21423!;*00B#003!3090*!52'XB2*8!()!016260!8*$90!O)80<
To Next Page
Loading...
