PrimaLuna EVO 100 - Safety, Package, and Setup; General Safety Precautions; Package Contents and Initial Setup

5
EvoLution Series
Warning
To prevent serious injury, electrical shock or fire:
 Do not operate with the bottom plate removed. Keep away from rain and moisture.
 Disconnect the ac mains cable before changing fuses and/or tubes.
 Do not replace fuses with any fuse other than the same type and rating as used by the factory.
 Do not replace tubes without reading instructions.
 Do not replace fuses or tubes if you have any doubt about your ability to do so.
 We accept no responsibility for any personal or material damage due to incompetent use or users.
Package Contents
EVO Tube Poweramplifier 1 piece
EVO Remote Control 1 piece
Power Cord 1 piece
This Owner's Manual 1 piece
White Gloves 1 pair
Tube Complement See specification pages
Spare Mains Littelfuse Model 213 fuse 1 piece
Spare Adaptive Auto Bias Littelfuse Model 213 fuse 1 piece
Initial Setup
 Don't wear a watch or rings and carefully remove the EVO Tube Poweramplifier from its packaging.
Once the plastic bag has been removed, use the white gloves to prevent fingerprint smudges.
 Remove the tube cage by carefully pulling it up and away from the amplifier.
 Remove the protective foam surrounding the tubes.
 Tubes are already installed.
 Check that each tube is firmly and straightly seated in its socket. Use gloves provided.
 Replace cage back in its place if desired.
 Check to see the power switch is off (down) and the bias-selector switch is in the correct position.
 Connect output of preamp with input of power amp.
 Connect your speaker wires, positive to positive, negative to negative. This unit is non-inverting.
 Plug the power cord into the amplifier, then into the wall socket.
 Switch on the sources and after that the preamplifier and wait for 1 minute to stabilize the circuit.
 Switch the power amplifier on.
 The tubes will be warmed up and ready to use in about 60 seconds.