Menu: MEM (Memory)
MEM 2
View test results
Selection b) You selected “View all data” to see the stored test results for
the respective address data set with all parameters.
Use buttons 2 and 3 to scroll through the saved test results. These will be
shown chronologically. If you have defined ideal ranges (Menu Setup) the
values will be rated with “Low / OK / High”. Press button 4 to change the
unit in which this value is displayed (e.g. “mg/l CaCO ” to “°dH”), as far as
3
available, or immediately delete the entry.
Pressing button 1 will take you back up or back in the menu one step.
Continued...
4
1
2
3
MEM 2
To Next Page
Loading...