Maintenance and
Section 4
Troubleshooting
Procedures not specifically explained in this manual
must be performed only by a qualified technician.
! WARNING
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION OR ELECTRIC SHOCK:
Make sure the power Switch of the Plasma Cutter is in its "OFF" position
and that the Plasma Cutter is unplugged from the electrical outlet before
performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM PLASMA CUTTER FAILURE:
Do not use damaged equipment.lf abnormal noise, vibration, or leaking air
occurs, have the problem corrected before further use.
Cleaning and Maintenance
Note: These procedures are in addition to the regular checks and maintenance
explained as part of the regular operation of the air-operated tool.
1.
2.
3.
BEFORE EACH USE,disassemble
Torch, inspect and replace worn
components, then reassemble
Torch tightly according to on
page 25.
Daily - Air Supply Maintenance:
Every day, maintain the air supply
according to the component
manufacturers' instructions. Drain
the dryer regularly. Performing
routine air supply maintenance
will allow the tool to operate more
safely and will also reduce wear on
the tool.
PERIODICALLY, blow the dust from
the cooling vents with compressed
air. If the unit repeatedly shuts
down from thermal overload, stop
all use.
4.
5.
6.
7.
PRIME-WELD CUT 60 User Mannual
Have the Plasma Cutter inspected
and repaired by a qualified service
technician.
Opening the Plasma Cutter will
void the warranty, and may
result in damage to equipment
or possible personal injury. DO
NOT OPEN THE HOUSING Any
repairs must be completed by a
qualified technician.
Store the Plasma Cutter and
accessories in a clean and dry
location out of reach of children.
WARNING! If the supply cord of
this Plasma Cutter is damaged,
it must be replaced only by a
qualified service technician.
24
To Next Page
Loading...
