BASIC WELDING TECHNIQUE
When welding is complete, set
the MIG Gun down on a heat
proof, electrically non-conductive
surface. Turn the Power Switch OFF.
Allow Welder to cool down, then
unplug the Power Cord.
Remove Ground Clamp from
workpiece or table and disconnect
MIG Gun.
Respool wire by clipping wire,
removing gas nozzle/contact tip on
MIG Gun, releasing Idler Arm on Wire
Feed mechanism, and rotating the
Wire Spool counterclockwise. Be sure
to securely hold wire as it is being
respooled because the end of wire
has a tendency to quickly unravel
once it clears the wire feeder.
MIG ONLY:
Close shielding gas cylinder valve
securely. Remove Regulator and
replace cap. Disconnect Gas Hose
from Welder. Store and secure gas
cylinder.
Peld
MIG Gun
OWNER'SMANUAL 1
34
To Next Page
Loading...
