SETUP MODE
Once batteries are installed and an SD card is inserted, you’re ready to go into the Setup Mode to get the
camera ready to use, with all options set to your preferences. While this can be done in the field (no
computer or internet access is needed), most users will likely want to setup the camera at home, in
advance. There are only a few settings to make, so the process is quick and easy. To start setting up your
Primos Mug Shot Trail Camera:
1. To enter Setup Mode, move the Power Switch to the middle (AIM) position. The display will come on
and show the initial Setup screen (Fig.4).
2. Press the OK key to begin. When the display flashes, you can use the UP and DOWN key to
change the setting of the currently selected option or item.
3. When you finish changing a setting (or leaving it set “as is”), press OK to lock in the setting and
move to the next option / item. If there is a setting that you don’t need or want to change from the
default or current setting, simply press OK to confirm and skip to the next item / option. Once you go
through the Setup Mode items and change a few settings, you’ll quickly see how this works.
Setting Time and Date (Fig.5)
After the initial Setup screen, the next few display screens will allow you to set the current time and date,
so the time / date stamp imprinted on all your photos and videos will be accurate when captured by the
camera. To change the Time and Date to be current, starting at the default “12:00” screen:
1. Press OK and use UP/DOWN to set the hour (24 hr/military time format). Press OK to confirm.
2. Use UP/DOWN to set the minute. Press OK to confirm.
3. Use UP/DOWN to set the month. Press OK to confirm.
4. Use UP/DOWN to set the date. Press OK to confirm.
5. Use UP/DOWN to set the year. Press OK to confirm and move on to the next Setup item, Camera
ID#.
Setting Capture Mode (1 photo, 3 photos, or video) (Fig.6)
Use UP/DOWN to select your preferred image capture mode: Single Photo per trigger (display shows 1
To Next Page
Loading...
