Primos 65063 - Inserting SD Card

6 NEW batteries are recommended because mixed old
and new batteries may result in shorter working time.
The camera display will show “LOBT” when the
battery is low.
Inserting SD Card：
The Primos Mug Shot camera uses a standard SD
memory card to save your photos (.jpg format) or videos
(.avi format). SD and SDHC (high capacity) class 6 or
hi ghe r s pe e d c a rd s , up t o a m axi mum 3 2G B ar e
supported. A Class 10 memory card is recommended
when the camera works at burst mode.
Make sure that the write-protect switch on the side of
the card is “off” (NOT in the “Lock” position). With the
power switch in the OFF position, insert the SD card i
n the
slot on the right side of the camera until it clicks in place. If
the wrong side of the card is facing up, you will not be able
to insert it without force-there is only once correct way to
insert cards.
If the SD card is not insert correctly, or no card is in the
slot, “CArd” will appear on the LCD display (Fig. 3)., and
the camera will not operate. Other card status display
messages:”FULL” indicates the card's memory is full, with
no remaining room to store files. “Err” means there is a
card rea
ding error (try a different SD card).
Formatting the SD card before using it for the first time
is recommended, especially when a card has been used
in other devices. This can be done using the camera's
“Format” function. Make sure you have backed up (saved
to your computer) any fi les you want to keep on a
previously used card, as formatting erases ALL files.
To take out the SD card, just gently push in the card (do
not try to pull it out without pushing it first). The card is
rel
eased from the slot and ready to be removed when you
hear the click. Be sure the camera's power is switched
OFF before removing or inserting SD cards.