SETUP MODE
Once batteries are installed and an SD card is inserted,
you’re ready to go into the Setup Mode to get the camera
ready to use, with all options set to your preferences.
While this can be done in the field (no computer or internet
access is needed), most users will likely want to setup the
camera at home, in advance. There are only a few
settings to make, so the process is quick and easy. To
start setting up your Primos Mug Shot Trail Camera:
1.To enter Setup Mode, move the Power Switch to
the
middle (AIM) position. The display will come on and show
the initial Setup screen (Fig.4).
2.Press the OK key to begin. When the display flashes,
you can use the UP and DOWN key to change the setting
of the currently selected option or item.
3.When you finish changing a setting (or leaving it set “as
is”), press OK to lock in the setting and move to the next
option / item. If there is a setting that you don’t need or
want to change from the default or current setting, simply
press OK to confirm and s
kip to the next item / option.
Once you go through the Setup Mode items and change a
few settings, you’ll quickly see how this works.
Setting Time and Date (Fig.5)
After the initial Setup screen, the next few display screens
will allow you to set the current time and date, so the time /
date stamp imprinted on all your photos and videos will be
accurate when captured by the camera. To change the
Time and Date to be current, starting at the default “12:00”
screen:
1.Press OK and use UP/DOWN to set the hour (24
hr/military time format). Press O
K to confirm.
2.Use UP/DOWN to set the minute. Press OK to confirm.
3.Use UP/DOWN to set the month. Press OK to confirm.
4.Use UP/DOWN to set the date. Press OK to confirm.
5.Use UP/DOWN to set the year. Press OK to confirm and
move on to the next Setup item, Camera ID#.
To Next Page
Loading...
