Setting Capture Mode (1 photo, 3 photos, or
video) (Fig.6)
Use UP/DOWN to select your preferred image capture
mode: Single Photo per trigger (display shows 1 + a
camera icon), Rapid Sequence of 3 Photos per trigger
(display shows a still camera icon + 3) or Video Clips that
are 10 seconds long at 720p resolution (display shows a
movie camera icon). Press OK after setting.
Sett i n g Came r a ID # (if us i n g mult i p le
cameras) (Fig.7)
Use UP/DOWN to select a reference ID# (from “01” to
“99”) for this camera, which will be imprinted on all
photos/videos along with the time&date. If you are only
using a single camera to monitor an area, simply leave it
set to the default “Id:01”. Set a second camera that will be
used in a group of multiple cameras to “02”, etc. Press OK
after setting.
SD Card Format (delete all files) (Fig.8)
This display will show “FOrN”. CAUTION: be sure to
backup and save any/all files you want to keep first, as
formatting will clear the card completely of all files
-they
will then be diffi cult or impossible to recover from the
card.
If you are sure you want to format a previously used card,
use UP/DOWN to change the “N” after “FOr_” to “Y” (Yes),
then press OK to confirm and delete all files from the card.
Restore Default Setting (initialize camera
setup) (Fig.9)
The display will show “dEFN”. To return the Camera ID# to
their original, “factory default” settings, use UP/DOWN to
change the “N” after “dEF_” to “Y” (Yes), then press OK to
confirm. Note: your time
and date settings will not be
changed from the current settings to the original defaults,
and your SD card will not be formatted. Only the Camera
ID# will be restored to their defaults.
To Next Page
Loading...
