Princess auto pro point

Questions and Answers

G
Guy MitchellAug 3, 2025
What to do if Princess auto pro point Saw motor will not start or stops suddenly?
- J
  jonathan66Aug 4, 2025
  If the motor of your Princess auto Saw doesn't start or stops suddenly, here are a few things to check: * First, ensure the plug is properly connected to a power source. * If there's a current overload, release the trigger and then squeeze it again. * If these steps don't work, the motor, switch, power cable, or plug may be defective. In this case, have a qualified electrician or service personnel inspect these items.
P
patrickcampbellAug 9, 2025
Why does my Princess auto pro point Saw overload trip frequently?
- S
  Scott PadillaAug 9, 2025
  Frequent overload tripping in your Princess auto Saw can stem from a few causes: 1. The motor might be overheating. Ensure the motor air intakes are clear, and run the saw without any load for a short period. 2. Excessive down-feed pressure could also be the culprit. Try reducing the down-feed pressure. 3. If the issue persists, the motor itself may be faulty and require inspection by a qualified electrician or service personnel.
J
jonathanwardAug 13, 2025
Why are my cuts not square with Princess auto Saw?
- K
  Kimberly VaughnAug 13, 2025
  If your cuts aren't square, consider these potential causes: * Too much down-feed pressure can cause inaccurate cuts; decrease the pressure. * Ensure the 90° angle stop is correctly set. * Also, double-check the positioning and clamping of the work-piece in the vise. * Poor blade tension can also lead to this issue; increase the blade tension. * Incorrect blade selection in relation to work-piece may be the reason. See the cutting recommendation p.25 (blade teeth, cutting speed). * Incorrect adjustment of blade guides may be the reason. Adjust outer bearings to contact the blade lightly.
C
Carol BrownAug 19, 2025
What causes excessive vibration in a Princess auto Band Saw?
- L
  Lance GibsonSep 12, 2025
  Excessive vibration in your Princess auto Band Saw can be due to several factors: * If the stand is on an uneven surface, adjust it for even support. * Cracks in the saw blade can also cause vibration, so replace the blade immediately if you notice any. * Cutting too heavily can also lead to vibration. Reduce down-feed pressure and blade speed.
D
David LopezAug 23, 2025
How to fix inaccurate miter cuts on a Princess auto Saw?
- M
  Michael LynchAug 25, 2025
  Inaccurate miter cuts on your Princess auto Saw can be corrected by: * Adjusting the miter stops to the correct positions. Use an adjustable square or protractor to check angle settings. * Also, ensure that the blade guides are set correctly by adjusting the outer bearings to contact the blade lightly.
J
Joseph WilliamsAug 28, 2025
What to do if finished surface of work-piece is rough, unsatisfactory with Princess auto Saw?
- C
  Cheryl RamseyAug 29, 2025
  If the finished surface of your work-piece is rough or unsatisfactory when using the Princess auto Saw: * The blade might be dull or not suitable for the thickness of the material. See the cutting recommendation p.25 (blade teeth, cutting speed). * Too much down-feed pressure can also cause this issue; reduce the down-feed pressure. * In addition, low blade tension can contribute to a rough finish, so increase the blade tension.