Instruction manual
8
DEHUMIDIFY MODE SETTINGS
Manual humidity set operation:
In this mode you can set a custom humidity level from 30 to 90%. The
dehumidifier will work to reduce the humidity providing the room
humidity level is above the set level.
Once the humidity is reduced the compressor will automatically turn
off and the fan will continue to run. If the humidity level rises again
then the compressor will begin again.
CO (Continuous) operation:
In this mode the dehumidifier will continuously run regardless of the
room humidity. The fan speed can be adjusted.
AU (Automatic) operation:
In this mode the dehumidifier will operate automatically to the below
levels:
Room temperature 5c to 20c = 60% humidity.
Room temperature 20c to 27c = 55% humidity.
Room temperature above 27c = 50% humidity.
Laundry mode:
In this mode the dehumidifier is in full power operation and will
continue to operate regardless of the humidity level. The fan speed is
locked on high and cannot be adjusted.
Fan mode:
In this mode the dehumidifier will only operate for air circulation and
the compressor will not run. The humidity will not be reduced in this
mode.
Water full:
If the water tank is full the full indicator will show red and an alarm will
sound. Empty and replace the water tank and the dehumidifier will
automatically resume its set operation.
NOTE: The compressor will not begin until 3 minutes has passed.
Automatic Defrost:
It is possible that the dehumidifier can produce internal frost. This is
normal and the dehumidifier will automatically go into defrost mode
when frost is detected to reduce this.
The compressor will turn off and the fan will continue, once the
defrost has finished the compressor will start and normal operation
will continue.
To Next Page
Loading...