Why does my Prior Lumen200 Laboratory Equipment show an 'Over Temp Fault'?
If your Prior Laboratory Equipment displays an 'Over Temp Fault', the bulb might be overheating. Ensure that the vents at the rear of the unit are not blocked or covered to allow for proper ventilation.
How to fix 'Bulb Fault 1' on Prior Lumen200?
If your Prior Laboratory Equipment indicates 'Bulb Fault 1', it could be due to the software not recognizing the hour count from the bulb. To resolve this, switch off the unit. Inspect the bulb for any signs of damage and ensure that the data connector is securely inserted into its socket on the bulb PCB.
What to do if my Prior Lumen200 Laboratory Equipment says 'CHANGE BULB'?
If your Prior Laboratory Equipment displays 'CHANGE BULB', replace the bulb.
What to do if Prior Lumen200 shows 'Under Temp Fault'?
If your Prior Laboratory Equipment shows an 'Under Temp Fault', make sure the unit is above 10 degrees Celsius and contact Prior.
General safety rules, warnings about water, temperature, and handling.
Explains safety features and definitions of warning labels such as UV and hot surfaces.
Guidelines for safely shipping and storing the Lumen unit and its components.
Overall specifications including power input, temperature range, and clearance for all Lumen models.
Details the Lumen 200's manual shutter, temperature-controlled bulb, and optical coupling.
Details the Lumen 200S's integrated high-speed shutter and control options.
Details the Lumen 200Pro's filter wheel, advanced shutter, and controller requirements.
Information on liquid light guide lifespan, degradation causes, and recommended operating temperatures.
Illustrates and labels the main components of the Lumen 200 unit.
Procedures for installing the Lumen 200, including bulb replacement and connecting to a microscope.
Steps for safely powering up the Lumen 200 after installation.
How to control light intensity using the manual shutter control knob.
Warnings and procedures for correctly shutting down the Lumen 200 unit.
Information on the bulb timer and alarm indication for replacement.
Illustrates and labels the main components of the Lumen 200S unit.
Procedures for installing the Lumen 200S, including bulb replacement and connections.
Instructions for connecting and installing drivers for the Lumen 200S with a PC.
Guidance on connecting the Lumen 200S to OptiScan or ProScan controllers.
Steps for safely powering up the Lumen 200S after installation.
Explains operation as standalone, with PC/controllers, and TTL inputs.
Warnings and procedures for correctly shutting down the Lumen 200S unit.
Information on the bulb timer and alarm indication for replacement for the Lumen 200S.
Details RS232 commands for controlling the Lumen 200S when connected to a PC or controllers.
Illustrates and labels the main components of the Lumen 200Pro unit.
Procedures for installing the Lumen 200Pro, including bulb replacement and connections.
Steps for connecting the Lumen 200Pro's liquid light guide to the microscope.
Guidance on connecting the Lumen 200Pro to OptiScan or ProScan controllers.
Instructions for connecting the Lumen 200Pro to a Prior PCI controller system.
Procedures for changing filters within the Lumen 200Pro's filter wheel.
Steps for safely powering up the Lumen 200Pro after installation.
Explains manual, PC, and OptiScan/ProScan control options for the Lumen 200Pro.
Warnings and procedures for correctly shutting down the Lumen 200Pro unit.
Information on the bulb timer and alarm indication for replacement for the Lumen 200Pro.
Explains Lumen warnings, alarm reasons, quiet alarms, and recommended actions.
Provides solutions for common problems like no light output or dim illumination.
Provides contact details for service and repairs from different global Prior Scientific offices.
General| Brand | Prior |
|---|---|
| Model | Lumen200 |
| Category | Laboratory Equipment |
| Language | English |
To Next Page