EasyManua.ls Logo

PRIXTON G100 - Troubleshooting; Cannot Power On; App Offline on First Launch

PRIXTON G100
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
According to users requirement, can set four period. In the period of setting time, the
watch’s GPS will work as the uploading interval mode what have set.
5.Setting GPS Work-time Length
Default length is 3 minutes, click location, the watch will open GPS immediately, uploading
interval per 10 seconds. It will recover to the work mode what have set after 3 minutes.Users can
set the GPS work time length between 1 minute to 30 minutes according to their own requirement.
6.Setting low battery alarm
The Watch battery capacity display in percentage. If less than 15%, it will alarm after 5
minutes. The watch will send alarm message to the APP.
7. Setting take off alarm
The watch have a sensor on the strap. If wearing time is above 3 minutes, it will alarm when
take off the watch. The watch will send alarm message to the center number (default closed), and
send the alarm notice to APP.
8.Setting Pedometer
The watch have vibration sensor. Users can turn on the pedometer function during exercise, it
will begin to counter steps, the watch will indicate the users’ steps number real time so that the
users can know the exercise station through the APP. The watch pedometer state will change to
week after turn off the pedometer function.
9. Remote Shutdown
Watches can be shutdown by press the key without SIM card” , press the key with SIM
card”, remote shutdown by APP and “outage
The method of pressing the key with SIM card to shutdown is as follows,
Step 1: Short press SOS button 5 times;
Step 2: Short press Key 1 one time;
Step 3: Short press Key 2 one time.
VII. Troubleshooting
6.1 Can’t power on
i. The battery has no power, connecting charger to charge one hour ( it will be full )
ii. Check the battery wiring is solid or not .
6.2 When turning on the watch first time, App end displays off -line after landing. Please check: