Pro-face GP-4501TW - Certifications and Standards

To Next Page

To Previous Page

GP4000 Series Hardware Manual

Certifications and Standards

Note:

z For information on the certifications and standards of the rear mount model, refer

to Certifications and Standards (see page 173).

Introduction

Pro-face submitted this product for independent testing and qualification by third-

party listing agencies. These agencies have certified this product as meeting the

following standards.

Agency Certifications

The GP unit is manufactured in accordance with:

z UL 508 and CSA C22.2 n°142 for Industrial Control Equipment

z Standard ANSI/ISA - 12.12.01 and CSA C22.2 n°213 for Electrical Equipment for

Use in Class I, Division 2 Hazardous Locations

Note:

z For use in Pollution Degree 2 environments.

z For use on a flat surface of a Type 1, Type 4X (Indoor Use Only) or Type 13

Enclosure.

z 24 Vdc input panel must be used with a Class 2 power supply.

z Suitable for use in Class I, Division 2 Groups A, B, C, and D Hazardous

Locations.

Hazardous Substances

The GP is a device for use in factory systems. When using the GP in a system, the

system should comply with the following standards in regards to the installation

environment and handling:

z WEEE, Directive 2012/19/EU

z RoHS, Directive 2011/65/EU

z RoHS China, Standard SJ/T 11363-2006

CE Markings

This product conforms to the necessary requirements of the following Directives for

applying the CE label:

z 2006/95/EC Low Voltage Directive

z 2004/108/EC EMC Directive

This conformity is based on compliance with EN61000-6-4, EN61000-6-2 (DC

model, AC model)

This conformity is based on compliance with EN60950-1 (AC model)

For information on Standards and Regulations, such as certified models and

certificates, see the following.

http://www.pro-face.com/worldwide.html

Other manuals for Pro-face GP-4501TW