34/55
3.5 Change the Display Unit Type
(* Only when replacing with GP-4501T)
Open the project file (*.prx) on GP-Pro EX that is converted in the Chapter 3.4 and
change the display unit type to GP-4501T.
(1) Open the converted project file (*.prx) on GP-Pro EX.
(2) Click [System Settings]->[Display]->[Change Display] in [Project] menu and
change the Display Unit type to GP-4501T.
(3) Click [Project]->[Save] or [Save As] to save the change.
3.6 Transfer the screen data to GP-4501T/TW
Transfer the project file after conversion to GP-4501T/TW.
You can transfer data to GP-4501T/TW via;
・ An USB transfer cable (model: CA3-USBCB-01)
・ An USB data transfer cable (model: ZC9USCBMB1)
・ A commercial USB cable (USB Type A/mini B)
・ A SD card/A USB storage device
・ Ethernet
But, this section explains, as an example, how to transfer screen data with an USB
transfer cable (model: CA3-USBCB-01).
To Next Page
Loading...
Need help?
General
