EasyManua.ls Logo

Pro-Ject Audio Systems Head Box S2 - Page 4

Pro-Ject Audio Systems Head Box S2
4 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© Pro-Ject Audio Systems · Pro-Ject Head Box S2 · Revision 2017.09.05
4
Technical data
Output power 725mW (into 32ohms)
Signal to noise ratio -110dBV
THD +N < 0.002%
Gain 11dB
Crosstalk 68dB
Frequency response 20Hz - 80kHz (+- 0,2dB)
Analogue inputs 1 pair RCA/Cinch
Headphone output 1x 6.3mm jack, 1x 3.5mm jack
Analgoue loop out 1 pair RCA/Cinch
Power supply 5V/0.5A DC
Standby Power Consumtion <0,5W
Dimensions W x H x D 103 x 37 x 120mm
Weight 365g without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only if the problem cannot be resolved there, the unit should be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright
©
2017. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.

Related product manuals