Pro-Line System CS300FU - Command and Safety Device Connections; Terminal Block Allocation Overview; Terminal X4 Configurations

6.4 Allocation of connections for command
and safety devices
Com mand and safety devices can be connected to termina Is
X3, X4 and X5.
Terminal block X3
Terminal block X4
- CLOSE switch
- impulse switch
1
-OPEN switch
- STOP switch, Wicket door switch,
draw-in protection
- Emergency off, slack rope switch
(for optoelectronic safety edge protection)
1
sequence control
2
button or selector switch
3
effective in dawn direction
- PART- OPEN
2
- safety edge protection
OPTO
- photoelectric
drive-through barrier
3
- 24 V DC 1 250 mN
4
for external switching devices
(connection to terminals 1 and 2)
wt: white
gr: green
br: brown
Terminal block X4
(for 8.2 kOhm safety edge protection)
- PART - OPEN
2
- safety edge protection
- photoelectric drive-through barrier
3
- 24 V DC 1 250 mN
Terminal block X4
(for pneumatic safety edge protection - pressure sensor test:
- A 8.2 kO hm resistor must be connected in series
- The input parameter SEP TEST must be switched on)
- PART- OPEN
2
- safety edge protection
- photoelectric drive-through barrier
3
- 24 V DC/ 250 mN
Terminal block X4
(for three-wire photoelectric barrier)
9
8
7
6
5
4
3
- Three-wire photoelectric barrier
2
1