Pro-Line System CS300FU User Manual

6.3 Mains connection
Danger!
To guarantee that the controls function pro-
perly, the following points must be ensured :
-
The mains voltage must correspond to the
vo/tage stated on the type plate .
-
For a permanent connection, an
all-pole main switch must be used.
- The drive cover must be closed.
Warning!
Before switching on the controls for the first
time, a check must be carried out after com-
p/eting the wiring to ensure that all the motor
connections at the motor and at the controls
are securely fixed. All control voltage inputs
are galvanically isolated from the supply
For all components to be connected to the
controls, at /east one additional isolation with
a rated voltage of> 230 V is recommended .
Detailed circuit diagram for mains connection
(230 V AC 1-phase 10.75 KW)
,1' ,IJ
Tl Jf
2 4 6
lZJ:3
= 1=1=
= =
==
= 1=
= = =
1~ 1 ~ 1 ~
~ ~
~~~ ~ ~ ~
~ ~ ~
1
.-i INIM w w1w ~ ~ .-iN M
_J _J _J z 0.... o.... o... 0.... _J_J _J z
Detailed circuit diagram for mains connection
(400 V AC 3-phase /1.5 KW or 3 KW)
J, ,IJ
Tl ,r
2
4 6
lZJ:3
= 1=
=
= 1=1= = 1 === 1= 1=
1~
~ ~ ~
~ ~ ~
~ 1 ~ 1 ~1~ 1 ~ 1 ~1
1 1 1 1
.-i
NM w 1 ww l ~ l .-i i N I M I
_J
-l -lZO.... 0....0.... O... -l-l -l Z
Key:
X1: terminal block for mains connection
Connection:
O Connect the control to the mains.
o Short before the corresponding screw terminals, groups of
cables should be make safe by means of stra ps .
Information:
Technical data see page 26 .

Pro-Line System CS300FU Specifications

General

Brand	Pro-Line System
Model	CS300FU
Category	Controller
Language	English