Pro-Line System CS300FU - LCD Monitor Programming Modes; LCD Monitor Overview and Key; Operating Modes: AUTOMATIC and ADJUSTMENT; Operating Modes: INPUT and DIAGNOSIS

'~)
7.1 Overview of the LCD monitor
H
A -++---t+AUTOMATIC
8
RESTING
Key:
A:
B:
C:
D:
E:
F:
G:
H:
C D
mode of operation 1 diagnostic info
parameter 1 diagnostic info
(+)button
(-)button
(P) button
value 1 status
value 1 status
jumper
E
0 -H---++ G
++-++ F
7.2 LCD monitor, mod es of operation
The control has four modes of operation with the LCD
monitor:
1. AUTO MATIC
2. ADJUSTMENT
3.1NPUT
4. DIAGNOSIS
When the jumper H is pul led, the + button,
the - button and the P button have no function.
The display stili functions.
Operating mode 1: AUTO MATIC
ln the AUTO MATIC operating mode the door system is
operated.
Display:
- displays the function being carried out
- displays any error messages
lf the .,self locking" parameter is set to MOD2 or MOD3 in
the input menu, the display changes from AUTOMATIC to
MANUAL OPERATION.
Operating mode 2: ADJUSTMENT
ln the ADJUSTMENT mode, the OPEN/CLOSED end position
settings are adjusted .
Warning!
ln the ADJUSTMENT mode of operation,
the drive does not switch off when the end
position is reached.
The drive moves at maximum speed.
The door can be damaged if driven beyond
the end position.
Fine adjustments can be made in the INPUT operating mode .
Display:
- displays the end position value
Operating mode 3: INPUT
ln the INPUT operating mode, the values of various parame-
ters can be altered.
Display:
- displays the selected parameter
- displays the program med value /status
Operating mode 4: DIAGNOSIS
ln the DIAGNOSIS operating mode, door-specific checks can
be queried.
Display
- displays the check
- displays the checking status