PRO-PULSE JF72553B - Switch On;Off; Overload Protection

JF72553B
46
You can now angle the saw blade by turning the hand wheel. Lock
the setting by tightening the fastening screw (3) (Fig. 3).
SWITCH ON/OFF
The ON/OFF switch (U) has a removable key (1). When the key has
been removed unauthorized persons or children cannot switch the
saw on.
1. To switch on the saw insert the key (1) into the slot in the key
switch (Fig. 1 ).
2. Push the ON/OFF switch up to switch the saw on. Push the ON/
OFF switch down to switch the saw off (Fig. 2).
OVERLOAD PROTECTION
This saw has an overload reset button (RESET) that resets the
motor after it shuts off due to overloading or low voltage.
If the motor stops during operation, turn the ON / OFF switch to the
OFF position. Wait about ¿YH minutes for the motor to cool, the push
the reset button (RESET) and turn the switch to the ON position.
¿J 1).
!
WARNING
The ON/OFF switch must be OFF and the saw must be unplugged
while the motor cools in order to avoid starting it accidentally by
pressing the reset button.
Overheating can be caused by badly aligned parts or by a blunt
blade. Ensure that the saw is correctly adjusted before reuse.
¿J

¿J
¿J
¿J
ASSEMBLY AND ADJUSTMENTS
ENGLISH