JF72553B
50
ENGLISH
MAINTENANCE
MAINTAINING YOUR TABLE SAW
GENERAL MAINTENANCE
For your own safety, turn the switch OFF and remove the switch key. Remove the plug from the
power source outlet before maintaining or lubricating your saw.
1. Clean out all sawdust that has accumulated inside the saw cabinet and the motor.
2. Polish the saw table with an automotive wax to keep it clean and to make it easier to slide the
workpiece.
3. Clean cutting blades with pitch and gum remover.
4. A worn, cut, or damaged power cord should be replaced immediately.
!
WARNING
All electrical or mechanical repairs should be attempted only by a trained repair technician. Contact
customer service for assistance. Use only identical replacement parts. Any other parts may create a
hazard.
5. Use liquid dishwashing detergent and water to clean all plastic parts.
NOTE: Certain cleaning chemicals can damage plastic parts.
6. Avoid use of cleaning chemicals or solvents, ammonia and household detergents containing
ammonia.
LUBRICATION
All motor bearings are permanently lubricated at the factory and require no additional lubrication.
On all mechanical parts of your table saw where a pivot or threaded rod are present, lubricate using
graphite or silicone. These dry lubricants will not hold sawdust as would oil or grease.
!
WARNING
To Next Page
Loading...
