3. Read from the display of measurement results.
Notes:
Measuring a large capacitance may take 10 seconds or longer to measure the correct results.
C) Temperature measurement
1. Press the “ ℃℉ ” key to switch to capacitance test mode.
2. Connect the temperature sensor black plug and red plug to COM input socket and V input
socket respectively.
3. Put the temperature sensor probe into the object, the probe must fully contact with the
object and the temperature rises completely.
4. Read from the display of measurement results.
NCV test (non-contact voltage detection)
Press the ON/OFF key to start it on.
Press the " H/NCV" key and hold, then near the instrument non-contact voltage sensing
area (less than 5mm) wire AC voltage.
The instrument red and yellow indicators are flashing, while the buzzer calls rapidly, in-
dicating the AC voltage of the measured wire.
Warning
Do not determine whether the conductor has a voltage only by non-contact power measurement.
Otherwise, there may be electric shock!
Current measurement (DCA & ACA)
Do not attempt a measurement on the current in a circuit, if when the voltage between the
open-circuit voltage and the ground is over 250V. If the fuse is blown at the moment of measure-
ment, you are likely to damage the meter or get yourself hurt.
To avoid any damage to the meter or equipment to be measured, do not attempt a current
measurement unless you have examined the meter's protective fuse. In attempting a meas-
urement, you should use the correct input sockets, function positions and measuring ranges.
When a test lead is inserted into the current input socket, do not put the other end of the test
lead in parallel connection with any circuit.
Press ON/OFF key to turn it on.
Connect the black test lead in to COM input socket
and red test lead in to 10A input socket respectively.
Disconnect the circuit to be measured. Connect the
black test lead to the lower voltage end and the red
test lead in to the higher voltage end of the discon-
nected circuit.
Connect the power to the circuit and capture the
To Next Page
Loading...
