Pro's Kit SS-988 - User Manual

Questions and Answers

J
James ChristianAug 3, 2025
What to do if my Pro's Kit SS-988 Power Tool cannot melt solder?
- J
  Jerry SalinasAug 4, 2025
  If your Pro's Kit Power Tool cannot melt solder, first, ensure that the temperature is properly set. If the temperature is correct, check the nozzle for oxidation and replace it if necessary. If the nozzle is not heating up, you will need to return the tool to the dealer. Also, inspect the vacuum outlet connection and the glass tube installation to ensure there is no air escaping.
L
Lauren JohnsonAug 8, 2025
Why Pro's Kit SS-988 LCD has no display?
- T
  Tracy GarciaAug 9, 2025
  If the LCD on your Pro's Kit Power Tool is not displaying anything, the issue might be due to the power not being connected. Check the power connection and ensure it is properly plugged in. If the connection is good, the fuse might be blown. In that case, replace the fuse with a new one (3.15A / 250V).
D
David MillerAug 13, 2025
What to do if Pro's Kit SS-988 Power Tool cannot suction solder?
- G
  Gary WilkinsAug 14, 2025
  If your Pro's Kit Power Tool is unable to suction solder, the nozzle might be blocked. Try to unblock it using the cleaning pin while the tool is heating up. Also, ensure that the solder is completely melted before attempting to suction it.
J
Jennifer TownsendAug 18, 2025
How to fix Pro's Kit SS-988 Power Tool nozzle that cannot be unblocked?
- A
  Amy KingAug 19, 2025
  If you cannot unblock the nozzle of your Pro's Kit Power Tool, it's possible that solder waste has accumulated at the rear part of the heater. To resolve this, take off the glass tube, melt the solder waste with a soldering iron, and then use the cleaning pin to unblock the nozzle.
M
Mallory Hart DDSAug 25, 2025
What to do if Pro's Kit SS-988 has filter degradation?
- N
  nathanielsuarezAug 25, 2025
  If you notice filter degradation in your Pro's Kit Power Tool, replace the filter.
M
Matthew AndrewsAug 28, 2025
How to fix fail to set temperature on Pro's Kit Power Tool?
- T
  Thomas MorganAug 28, 2025
  If you are unable to set the temperature on your Pro's Kit Power Tool, the button might be broken. In this situation, return the tool to the dealer.