Thank you for purchasing Pro’sKit product. The SS-989 2in1 SMD Hot Air Rework Station
has been designed to meet high quality standards. Please properly use and care of your
product for prolonging service life.
For the complete user manual downloading,
SAFETY INSTRUCTIONS
WARNING
Warnings and cautions are placed at critical points in this manual to direct
the operator's attention to significant items. They are defined as follows:
WARNING: Failure to comply with a WARNING may result in serious injury
or death.
CAUTION: Failure to comply with a CAUTION may result in injury to the
operator, or damage to the items involved. Two examples are
given below.
NOTE : A NOTE indicates a procedure or point that is important to the process
being describe.
EXAMPLE : AN EXAMPLE is given to demonstrate a particular procedure, point
or process.
_ Be sure to comply with following WARNINGS and CAUTIONS for your
safety.
WARNING
_ Be sure not to operate the unit with any combination of temperature and air
flow settings that makes the thermal protector trip (the heater lamp turns off
during use). This could damage the unit.
CAUTION
When the power is ON, the temperature of the hot air and the nozzle
ranges from indoor temperature to 480°C ( 896°F). To avoid injury to
personnel or damage to items in the work area, observe the following:
_ Do not direct the hot air toward personnel or touch the metal parts near the
nozzle.
_ Do not use the product near combustible gases or flammable materials.
_ Advise those in the work area that the unit can reach very high temperatures
and should be considered potentially dangerous.
_ Turn the power OFF when no longer using the Pro’sKit SS-989 or when
leaving it unattended.
_ Before replacing parts or storing the unit, allow the unit to cool and then turn
the power OFF.
To prevent accidents and failures, be sure to take the following
precautions:
To Next Page
Loading...
