PR-4
Glossary of terms and abbreviations
CAN – Controller Area Network .
CKP – Crankshaft Position Sensor.
CMP – Camshaft Position Sensor.
DATALOG – Sample set of readings from a group of sensors, saved on a device with memory.
ECU – Engine Control Unit.
ET – Engine Temperature.
GPS – Global Position System.
IAT – Intake Air Temperature.
MAF – Mass Air Flow.
MAP – Manifold Absolute Pressure.
NTC – Negative Temperature Coefficient.
OBD II – On-Board Diagnostic II.
PEAK & HOLD – Activation strategy for low impedance fuel injectors.
PINOUT – Diagram, or pin configuration of a device.
TDC – Top Dead Center – Highest position of the piston inside the cylinder.
PP – Pedal Position Sensor.
PWM – Pulse Width Modulation.
RGB – Red Green Blue
SHIFT LIGHTS – Progressive lights with activation linked to engine speed.
TDL – Touch Dash Logger.
TP – Throttle Position.
TPS – Throttle Position Sensor.
USB - UNIVERSAL SERIAL BUS.
To Next Page