PROGRAMMING THE THERMOSTAT
5
Filter Change Reminder
If your installing contractor has configured
the thermostat to remind you when the air
filter needs changed, you will see FILT in the
display when your air filter needs changed.
FILT will be shown in the display after your
system has run long enough to require an air
filter change.
Resetting the filter change reminder: When
FILT reminder is displayed, you should
change your air filter and reset the reminder
by holding down the second button from the
top of the thermostat for 3 seconds.
Temporary and Permanent Hold Feature
Temporary hold: The thermostat will display
HOLD and RUN SCHED on the bottom of
your screen when you press the or
key. If you do nothing, the temperature will
remain at this setpoint temporarily for 4
hours. Your program setpoint will then
replace your temporary setpoint.
Permanent hold: If you press HOLD key at
the bottom of your screen, you will see HOLD
appear below the setpoint temperature in the
display. The thermostat will now permanently
stay at this setpoint and can be adjusted
using the
or keys.
To return to program: Press the RUN SCHED
key at the bottom of your screen to exit either
temporary or permanent hold.
To Next Page
Loading...
