5
ATTENTION: PLEASE READ THIS BEFORE USING TO PREVENT DAMAGE TO HEAD!
APPROPRIATELY MOUNT THE HEAD
The head must be aached securely with all knobs properly ghtened, to avoid
harm both to the equipment and crew.
ALWAYS ESTABLISH THE CORRECT BALANCE
If the camera is out of balance, both axis will not work.
NEVER MOVE ANY PART OF THE HEAD BY HAND!
The reducon drives in the motors hold each axis in place. To move by hand may
permanently damage the motor gearbox.
PROVIDE SLACK IN REMOTE HEAD CABLE
Leave the cable going from Head to Controller loose, to avoid tension. Tension will
damage the cable when crane is boomed up or down.
BE WATCHFUL WHILE HEAD IS IN MOTION
Do NOT put ngers or other body parts near the movable elements of head when
the Controller is switched on. It can result in wounds or other injuries.
FOLLOWING THESE GUIDELINES WILL PROVIDE BETTER SHOTS AND TROUBLE FREE
OPERATION.
SHOULD YOU NEED ADDITIONAL INFORMATION, TECHNICAL ASSISTANCE IS AVAILA-
BLE ‘ONLINE’ BY CONTACTING THE SALES REPRESENTATIVE.
Safety Hints
To Next Page
Loading...
