4
m 1. There are 4 plywood boat stand pieces. The 2 short
plywood pieces are the ends of the boat stand.
m 2. Secure the 2 long plywood pieces of the interlocking
boat stand to one end of the short plywood pieces.
Repeat with the remaining short plywood pieces.
m 3. Secure the stand together where each piece is joined
with epoxy or CA glue (not included).
m Unscrew the 2 knurled hatch-mounting screws from the
rear of the hatch. Slide the front hatch retainer toward
the rear of the boat and lift the hatch from the boat.
Receiver Batteries
m 1. Remove the ten 2.5mm hex head screws that secure
the radio box cover.
m 2. Remove the battery holder and install 4 AA alkaline
batteries in the polarity shown on the battery box.
Note: You may consider upgrading to a
rechargeable battery pack. We recommend
the DYN1453. See your local Pro Boat
dealer.
Recommended Radio Equipment
You will need a 2-channel transmitter. We recommend one of
the crystal-free, interference-free Spektrum
™
, Pro Boat or JR
®
radio systems using DSM
®
marine technology. Compatible tran-
mitters include:
m DX3E (SPM3160)
m DX2.0 (SPM20220)
m DX3.0 (SPM20320)
m DX2S (SPM2120)
m DX3S (SPM3140)
m Pro Boat Pistol Grip 2.4GHz (PRB8060)
m Spektrum and JR DSM2
™
aircraft transmitters
www.spektrumrc.com
Note: The radio system will require
binding (linking the receiver to the
transmitter). Please see your radio system's
manual for binding instructions.
Section 1:
Building the Boat Stand
Section 2:
Removing the Canopy
Section 3: Installing the
Radio System Batteries
To Next Page
Loading...
