ProBoat Westward 18 Sailboat RTR

Questions and Answers

K
Karen JohnsonAug 15, 2025
Why ProBoat Westward 18 Sailboat RTR moves too fast or too slow?
- A
  Aaron BrewerAug 15, 2025
  If your ProBoat Toy boat moves too fast or too slow for the wind and water conditions, the rigging may be worn, so repair or replace any damaged parts. The sails may be adjusted too tight, so loosen or adjust the sail rigging for the wind and water conditions. The steering rate may be incorrect on the transmitter for the wind and water conditions, so adjust the steering rate. Also check for vegetation or other obstacles blocking the rudder or keel; remove the boat from the water and clear any obstacles.
K
Kelly BennettAug 18, 2025
What to do if my ProBoat Westward 18 Sailboat RTR Toy will not link to the transmitter after binding?
- M
  Michelle FernandezAug 18, 2025
  If your ProBoat Toy isn't linking to the transmitter after binding, several factors could be at play. First, ensure the transmitter isn't too close to the boat during the linking process; move it a few feet away, then disconnect and reconnect the boat's battery. Similarly, large metal objects nearby can interfere, so relocate the boat or transmitter. Check that the bind plug isn't still installed in the bind port; if it is, rebind the transmitter to the boat and remove the plug before powering on. Low battery charge in either the boat or transmitter can also cause this issue, so replace or recharge the batteries. Finally, the transmitter might be bound to a different model using a different DSM Protocol; in this case, bind the boat to the transmitter again.
M
moorechelseaAug 22, 2025
Why my ProBoat Toy boat does not respond to the transmitter?
- A
  amanda53Aug 22, 2025
  If your ProBoat Toy boat isn't responding to the transmitter, there are a few things you can check. First, make sure the boat receiver is bound to the transmitter; if not, bind them. Next, ensure that both the boat and transmitter batteries have sufficient charge; replace or recharge them if necessary. Also, inspect all electrical connections to ensure they are secure. Finally, check for any obstructions or damage to the sails or lines; straighten, tighten, or replace any damaged rigging.
R
ramosstephanieAug 25, 2025
What to do if my ProBoat Toy boat will not respond to throttle?
- S
  snyderstevenAug 26, 2025
  If the ProBoat Toy boat will not respond to the throttle but responds to other controls, reset the controls with the throttle stick and throttle trim at the lowest setting. Ensure the throttle servo travel is 100% or greater. If the issue persists, reverse the throttle channel on the transmitter.
J
Jennifer BergerAug 28, 2025
Why my ProBoat Toy tends to dive in the water?
- M
  Mr. Tracy BeckAug 28, 2025
  If your ProBoat Toy tends to dive in the water or takes on water, consider these possible causes: the sails might be rigged too high or low on the mast, so adjust the tightness of the rigging at the top corner and bottom of each sail. Alternatively, the sails might be tied too tight, so loosen the lines. Also, check that the boat hull is completely closed; dry out the boat and ensure the hatch is fully closed before returning the boat to the water.
E
Elizabeth JohnsonAug 31, 2025
What to do if my ProBoat Westward 18 Sailboat RTR will not link to transmitter during binding?
- B
  benjaminriveraAug 31, 2025
  If your ProBoat Toy boat will not link to the transmitter during binding, the transmitter may be too near the boat; move the powered transmitter a few feet away, then disconnect and reconnect the battery to the boat. The boat or transmitter may be too close to a large metal object; move them away. The bind plug may not be installed correctly in the bind port; install it correctly and bind the boat to the transmitter. Also, the boat or transmitter battery charge may be too low; replace or recharge the batteries.
J
Jeffrey AcevedoSep 4, 2025
How to fix reversed controls on my ProBoat Toy?
- R
  richardwilliamsSep 4, 2025
  If the controls on your ProBoat Toy are reversed, the transmitter settings are likely reversed. Perform the Control Direction Test and adjust the controls on the transmitter appropriately.
M
michael78Sep 7, 2025
Why my ProBoat Westward 18 Sailboat RTR tends to drift?
- H
  Henry MayerSep 7, 2025
  If your ProBoat Toy tends to drift, center and adjust the sails and control lines for the wind and water conditions. If the issue continues, the rigging may be worn or broken, so repair or replace any damaged rigging.
A
Amy AllenSep 12, 2025
Why my ProBoat Westward 18 Sailboat RTR tends to turn one direction?
- E
  Eugene ShawSep 12, 2025
  If your ProBoat Toy tends to turn in one direction, the sails may not be centered. Center and adjust the sails and control lines for the wind and water conditions to correct this.