ProBoat PRB08014 - Box Contents; Recommended Tools and Materials; Battery and Battery Charger; Antenna Tube Installation

ShockWave
®
26
2.4GHZ DIGITAL
RADIO SYSTEM
Box Contents
• Pro Boat
®
ShockWave
®
26-Inch Brushless Deep-V Boat
• Spektrum™ STX2
®
2CH 2.4GHz FHSS Transmitter (SPMSTX200)
• Spektrum™ STX2
®
2CH 2.4GHz FHSS Receiver (SPMSRX200)
• Dynamite
®
30A Brushless 2–3S Marine ESC (DYNM3860)
• Spektrum™ 3KG 23T Plastic Gear Servo, Waterproof (SPMS603)
• Dynamite
®
2000Kv Brushless Marine Motor (DYNM3900)
4
EN
• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 4mm, 5.5mm, 8mm (DYNT0502)
• Phillips screwdriver: #1
• Hex wrench: 1.5mm, 2mm, 2.5mm, 3mm (DYNT0502)
• Clear tape (DYNM0102)
• Dynamite
®
Marine Grease and Gun (DYNE4200)
• Hook and Loop Tape Set, WP 4pcs (DYNK0300)
Antenna Tube Installation
Install the receiver antenna in the tube as shown.
Keep the end of the antenna above the boat’s waterline
to get the best transmitter reception. Apply clear tape
(DYNM0102), if desired.
NOTICE: Do not cut or kink the receiver antenna or
damage may result.
This product does not come with a battery. We
recommend the Dynamite
®
Reaction
®
7.4V 5000mAh 2S
30C LiPo Hardcase with EC3™ connectors.
This product does not come with a charger. Choose
a charger designed to charge the recomended battery.
We recommend either the Dynamite
®
Prophet
™
Sport LiPo 35W AC Charger (DYNC200CA) or the
Dynamite
®
Prophet
™
Sport Plus 50W AC/DC Charger
(DYNC2010CA). Refer to your charger manual for
charging instructions and safety information.
NOTICE: Never charge a battery in the boat or damage
may result.
Battery and Battery Charger
Recommended Tools and Materials
A battery (sold separately) is required to
operate the boat. The ESC will operate
with 2–3 Cell (7.4V–11.1V) Li-Po or 6–9 Cell
(7.2V–10.8V) Ni-MH/Ni-Cd batteries.