12 of 98 | English
EMPTYING THE WATER TANK
――
CAUTION: ALWAYS TURN THE UNIT OFF
AND REMOVE THE PLUG FROM THE WALL
OUTLET BEFORE REMOVING THE WATER
TANK.
Due to the large capacity of the water tank
it is recommended to run the appliance
until the water level is at the min line prior to
emptying the water tank.
Once the water level is at the min line, to
empty the water tank:
1. Turn off the appliance and unplug it from
the power socket.
2. Place a shallow tray underneath the
water outlet.
3. Remove the water tank plug clip and the
water tank plug and allow the water to
collect in the shallow tray.
4. To fully empty the water tank gently tilt
the appliance back on its rear wheels. Do
not tilt more than 30 degrees.
5. Once empty, return the appliance to a
fully upright position and replace the
water tank plug and water tank plug clip.
6. Empty the shallow tray.
7. Remove the lter casing from the rear of
the appliance to gain easy access to the
water tank.
8. Dry the water tank using a soft cloth.
9. Return the lter casing to the rear of the
appliance.
the appliance to gain easy access to the water tank.
3. Insert ice cubes and/or the two ice packs into the water tank.
4. Return the lter casing to the rear of the appliance.
Notes:
If the water level is too low three beeps will sound and the cooling mode indicator will continue to
ash until cooling mode is turned off and/or the water tank has been relled with water.
Place the ice packs in a freezer for at least four hours prior to use.
Do not ll the water tank over the max line or below the min line.
2 & 3.
4.
To Next Page
Loading...
Need help?
General
