ProBreeze PB-AC06 - Water Tank Filling Procedure; Emptying the Water Tank; Water Tank Emptying Procedure

English | 11 of 90
To ll the water tank:
1. Turn off the appliance and unplug it from
the power socket.
2. Unclip the lock and pull the water tank
out gently with both hands. Caution: the
water tank is connected to the device.
Do not force the water tank out.
3. On the base of the water tank, there is a
clip that connects the lter to the tank.
Turn the clip 90 degrees anticlockwise
and disconnect the lter from the water
tank.
4. Fill the water tank to the max line with
fresh water.
5. Slowly push the water tank halfway back
into the unit and re-attach the lter using
the clip lock clockwise.
6. Push the water tank back into the unit
and clip the lock back in place.
Note: For cooler air, simply add the
refrigerated, or frozen, ice packs into the
water tank.
Notes:
• If the water level is too low, the
humidication indicator will continue
to ash until the water tank has been
relled with water.
• Place the ice packs in a freezer for at
least four hours prior to use.
• Do not ll the water tank over the max
line or below the min line.
EMPTYING THE WATER TANK
――
Due to the large capacity of the water tank
it is recommended to run the appliance
until the water level is at the min line prior to
emptying the water tank.
To empty the tank:
1. Turn off the appliance and unplug it from
the power socket.
2. Place a shallow tray underneath the
2.
3.
5.
(2,3: Filling the water tank)
(5: Emptying the water tank)