Two-part connector.
•Male part fitted to module
•Female part supplied in module
packing case - Screw terminal, rising
clamp, no internal spring.
Example showing cable entry
and screw terminals of a 10
way connector.
1.0. Introduction
This document details the in-built features, operating procedure requirements of the DGC202X
Series modules. This document is subject to changes without prior notice.
DGC202X series is designed on a common platform and provided variants for different level of
functionality and economics. This allows system designers greater flexibility in the choice of
controller to use for a specific application.
The DGC202X series module has been designed to allow the operator to start and stop the
generator manually or automatically and transfer the load to the generator automatically.
DGC202X automatically starts and stops the generator set depending upon the status of the
mains (utility) supply. The user also has the facility to view the system operating parameters on
LCD display. Additionally, a special mode, Test Mode, is incorporated to facilitate easy debugging
during the building and testing a genset.
The DGC202X module monitors the engine, indicating the operational status. On detection of
faulty conditions, it automatically shutting down the engine. The LCD display indicates the fault
and warning.
The powerful microcontroller contained within the module allows for incorporation of a range of
complex features:
• Icon and Description based LCD display
• True RMS Voltage, Current monitoring
• USB Communications
• Engine parameter monitoring.
• Fully configurable inputs for use as alarms or a range of different functions.
• CAN bus for Engine ECU interface.
• Isolated and Protected RS485 with Modbus.
• Canopy Fan Current Monitoring for Air Cooled Engines.
A robust plastic case designed for front panel mounting houses the module. Connections are via
locking plug and sockets connectors.
All parameters can be changed from the module’s front panel, USB or RS485 communication.
Access to Program/Modify the parameter, through front keys, is protected through a password.
2.0 Model selection
3.0. Specifications
3.1 Terminal Specification
To Next Page
Loading...
