level:
• green = shows the normal operative level of the signal (from -20 to 0 dBpeak)
• yellow = shows the nominal operative level of the signal (from 0 to +6 dBpeak)
• red = shows a high signal level (near +20 dBpeak CLIP level).
15. +48V phantom switch and LED
This switch activates (LED on) and deactivates (LED Off) the phantom power on MIC Inputs. Most
professional condenser microphones require phantom power, which is a lower DC voltage delivered to the
microphone on pin 2 and 3 of the XLR microphone connector. Dynamic microphones do not require phantom
power, however phantom power will not harm most dynamic microphones should you plug one in while the
phantom power is on. Check the manual of your microphone to find out for sure whether or not phantom
power can damage it.
16. ON LED
Indicates when the mixer is switched on.
17. MAIN MIX L & R XLR output (balanced)
These XLR and provide a balanced line-level signal that represents the fully mixed stereo signal controlled by
the MAIN MIX fader. Connect these to the inputs of your power amplifier, powered speaker or other audio
processors.
NOTE: whenever possible, use always balanced cables. Unbalanced lines may also be used but they may
result in noise over long cable runs. In any case, avoid using a balanced cable for one channel and an
unbalanced one for the other.
18. MAIN MIX L & R jack output (balanced)
These jack connectors are connected in parallel to the respective XLR outputs.
19. PHONES stereo jack output
STEREO JACK connector for the headphones output: only stereo headphones with a minimum impedance of
32 Ohms should be connected to this output. The signal is always the same of MAIN MIX outputs.
20. 18V~ supply socket input
Here’s where you plug in your mixer’s external power supply. You should always connect your power supply
to the mixer before you plug the power supply into an electrical outlet.
21. POWER switch
Switch this one on and your mixer has power. Switch it off and it doesn’t. Make sure that all master output
knobs are turned all the way down when powering your mixer up or down.
22. Power cable hook
Use this hook to prevent power cable drawing: simply go through it before connecting the cable into the
18V~ socket.
To Next Page
Loading...