Need help?Do you have a question about the PROEL TARKUS 575 SPOT and is the answer not in the manual?
General| Brand | PROEL |
|---|---|
| Model | TARKUS 575 SPOT |
| Category | Lighting Equipment |
| Language | English |
Handle with care due to dangerous voltage, use correct outlets, and manage power cords safely.
Damages from disregarding the manual are not covered by warranty.
Allow device to reach room temperature after drastic fluctuations to prevent condensation damage.
Avoid contact with hot surfaces, direct light source, and keep away from untrained individuals.
Proper installation, handling, and environment are crucial for safe and effective operation.
Always use an appropriate safety rope fixed at correct points for secure installation.
Ensure housing is closed and lamp is not ignited with open covers to prevent hazards.
Adhere to maximum ambient temperature and ensure only qualified personnel operate the device.
Use original packaging for transport; unauthorized modifications are forbidden for safety.
Details on lamp, colours, gobos, effects, focus, prism, movements, DMX control, and norms.
Identification of key physical components like projector head, lens, yoke, handle, and display.
Procedure for safely installing or replacing the lamp, including cooling and handling precautions.
Step-by-step guide to unscrew cover, remove old lamp, insert new lamp, and reassemble.
Procedure for adjusting the lamp to achieve optimal and even light distribution.
Emphasizes national norms, secondary attachments, expert approval, and required experience for rigging.
Install out of reach, use professional systems, and be aware of severe injury risks from falling projectors.
Maintain 1.5m clearance from flammable materials and use appropriate clamps for secure truss mounting.
Properly route, secure as a closed ring, and ensure no defects or excessive drop distance for safety ropes.
Connects multiple fixtures in a DMX chain, specifying starting addresses and wiring rules.
Details the pinout for DMX-output (socket) and DMX-input (plug) XLR connectors.
Connects fixtures sequentially from DMX-output to DMX-input for chain operation.
Recommends using a DMX terminator to prevent signal corruption from external noise.
Connects the device to the mains using the provided power supply cable, detailing wire color codes.
Assigns starting channels to each projector for proper DMX signal direction and control.
Instructions on how to invert Pan and Tilt movement modes using the multifunctional knob.
Ensures no overlapping channels to control moving heads independently; addresses similar settings lead to similar operation.
Lists and describes the function of each DMX control channel for the moving head.
Enables operation without a DMX controller, performing automatic or music-synced light shows.
To Next Page
