Appendix 1
Over-Encapsulating Tablets into Capsules
4. Tilt the ATF to pour off excess tablets.
5. Place ATF locating studs into front holes
of OE Guide Tray.
6. Press release bar to drop the tablets into
the capsules.
7. For sizes A, B and D only, remove ATF
and repeat steps 3-6 except in step 5 place
the ATF locating studs into the second holes
of OE Guide Tray. Repeat steps 3-6 a third
time, placing ATF studs into third holes in
step 5.
8. For all sizes, remove ATF and OE Guide
Tray. Verify that tablets are inside all
capsule bodies.
Tip: To avoid tablet rattling, fill capsules with
excipient.
9. Continue with “Operating Instructions” in
your ProFiller 3700/3800 Manual. Begin with
“Filling Capsules” if adding an excipient (page
18 in Manual v 1.2.1), or continue with
“Locking Capsules” to lock the outer capsules
(page 20 in v 1.2.1).
To Next Page
Loading...