What to do if my Progress Equal-i-zer 90-00-0600 Automobile Accessories tow vehicle is too high in front?
If your tow vehicle is too high in the front, it could be due to insufficient weight distribution. To correct this, follow the “under adjustment” guidelines to add spacer washers or raise the L-bracket.
Why does the front end of my Progress Equal-i-zer 90-00-0600 feel "floaty"?
A "floaty" front end can be caused by insufficient weight distribution. Address this by following the “under adjustment” guidelines, which involve adding spacer washers or raising the L-bracket.
What to do if my Progress Equal-i-zer 90-00-0600 Automobile Accessories trailer is too low or too high in the front?
If your trailer is more than 1-1/2” from level, it may be due to: * Improper hitch ball height: Adjust the ball height by following the instructions in the Trailer Angle Adjustment section. * Improper hitch ball height because shank is too short: Consult your local Equal-i-zer hitch dealer about using a specialty length shank.
How to fix a “walking” sway bracket assembly on my Progress Equal-i-zer 90-00-0600?
A "walking" sway bracket assembly can result from: * Link plates under-tightened: Tighten the link plates correctly, following Step 4. * Link plates over-tightened and bowed: Tighten the link plates correctly, following Step 4. If a link plate is excessively bent, it should be replaced.
Why is my Progress Automobile Accessories trailer swaying?
Trailer sway can occur for several reasons: * Not enough weight distribution: Adjust by adding spacer washers or raising the L-bracket, following the “under adjustment” guidelines. * Tongue weight too light: Weigh the loaded trailer and tongue. Ensure the tongue weight is a minimum of 400lbs, typically 10%-15% of the Gross Trailer Weight. Consult the trailer manufacturer's guidelines and reposition the load. Remove any cargo carriers or secondary trailers from the rear. * Incorrect tire pressure: Check and inflate tires to the manufacturer's recommended pressure. * Loose socket bolts: Tighten socket bolts to between 45-65 ft. lbs. torque. * Tow capacity exceeded: Verify your tow vehicle's rating for the trailer's tongue weight and Gross Vehicle Weight. If it's insufficient, do n...
Explains how weight is transferred to axles for stability.
Details the integrated sway control mechanism and its function.
Explanation of hitch noise and methods to reduce or eliminate it.
General| Brand | Progress |
|---|---|
| Model | Equal-i-zer 90-00-0600 |
| Category | Automobile Accessories |
| Language | English |
To Next Page