Progress Equal-i-zer 90-00-0600 User Manual

19
A product of
3”
minimum
Retract the tongue jack until the weight
of the trailer settles onto the tow vehicle,
and the foot of the jack comes off the
ground about 1”.
Figure 12
Step 6 - Weight Distribution Adjustments:
Use the following guidelines to set up and adjust your Equal-i-zer for
weight distribution. Good weight distribution is a critical component of the
Equal-i-zer setup. A hitch that is set up poorly for weight distribution will
not perform like one that is set up well. Every tow vehicle and trailer com-
bination will react differently to weight distribution. Refer to Appendix B
“Weight Distribution Adjustments” on page 25 for a more detailed descrip-
tion of factors that inuence weight distribution.
Re-measure the tow vehicle heights exactly as done before in Step 1. Re-
cord these new measurements on line C of the weight distribution setup table.
Measure from ground
to fender through the
center-line of the axle.
Rear Front
Wheel Well Height Rear Front
A Tow vehicle loaded for trip but
still uncoupled from trailer
B Tow vehicle coupled but NO
weight distribution
C Tow vehicle coupled with weight
distribution engaged
Figure 13

Progress Equal-i-zer 90-00-0600 Specifications

General

Brand	Progress
Model	Equal-i-zer 90-00-0600
Category	Automobile Accessories
Language	English