Page 16 X30 Owner’s Handbook
compreSSor air Filter
electrical SyStem
timer / toggle Switch
air preSSure check
operatioN teSt
• Replace the compressor inlet air filter
annually or more often if dusty conditions
are encountered.
• Check the internal and the external wire harnesses
for damage. Replace if required.
• Check to see that both operate as described in
the Operation Manual.
• Correct air pressure is important – refer to the X30 Installation and Service manual SL9211 for
further information.
• Run the system for at least 15 minutes
or until the heater cycles “OFF”
and then “ON” again.
• Alternate the thermostat
for the sleeper heater
(if connected) between
the lowest and highest
settings to ensure that
the sleeper heater fan
cycles “ON”and “OFF”.
Caring for your PROHEAT
Remove Plug and Connect Fitting
Digital Manometer PK0036
Tor que to 50±5 In/Lbs
(5.6±0.7 Nm)
To Next Page
