EasyManuals Logo

Projecta INTELLI-START User Manual

Projecta INTELLI-START
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
FLOOD LIGHT
Step Detail Display
1 Press the light button and the light will turn on. Press the light button again to
turn the light off when you are finished.
Note: If the Jumpstarter is off and the light button is pressed, the button will
need to be pressed for at least half a second before the light will turn on.
POWER BANK
The Jumpstarter has a 2.1A USB output. It is suitable to charge phones, tablets, cameras,
and GPS devices. The Jumpstarter will turn off after 5 minutes of no activity or the USB
device has been fully charged.
If the USB output becomes overloaded (stops working), remove the device, and check it.
Turn the Jumpstarter off and back on again, the USB output should work again.
WARNING: Charging devices from the Jumpstarter will drain the battery. This can cause
the Jumpstarter to fail in starting your vehicle in an emergency. Recharge the Jumpstarter
as soon as possible.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Projecta INTELLI-START and is the answer not in the manual?

Projecta INTELLI-START Specifications

General IconGeneral
System TypeRemote Starter
Operating Voltage12V DC
InstallationProfessional installation recommended
Timer ModeYes
Temperature ModeYes
Battery ProtectionYes
Remote RangeUp to 1000 meters

Related product manuals