gloves when handling material. Refer to personal protection equipment for more information.
To avoid sensitization, do not allow uncured material to contact skin. Consult the GHS/SDS for
specic information about the sensitization potential.
If skin comes in contact with uncured material immediately wash with cold water and soap.
Inhalation/Ingestion
Under normal operation, inhalation is not an expected route of entry.
Ingestion - Uncured part material is toxic if ingested.
Because uncured material is toxic if ingested, it must not be present where food and drink are
stored, prepared, or consumed. After handling materials, wash hands with soap and cold water
before consuming or preparing food.
Handling Finished Parts
Finished (cured) parts can be handled or disposed of the same as standard household plastic
products. VisiJet® parts are not recyclable. VisiJet® materials are not intended for and cannot
be used for medical implant, food or drink handling applications.
Exposure control - The 3D printer system has a variety of built-in engineering controls which
are designed to prevent operator exposure. Do not try to change or disable these controls.
Skin Contact
Uncured part material is a sensitizer, and can cause allergic reactions if skin comes into
contact. When handling any part or waste material, always wear 100% nitrile gloves and lab
coats.
Should skin come into contact with uncured part material, wash thoroughly with soap and cold
water and immediately remove contaminated clothing and shoes. Do not use hot water or
solvents to wash hands, as it will result in absorption through the skin. If skin is irritated, seek
medical attention. Dry-clean contaminated clothing and discard contaminated shoes and
leather products in accordance with applicable regulations.
Eye Contact
Safety goggles with side shields should be worn to prevent accidental splashes into the eyes. If
material comes in contact with the eye, ush immediately with large amounts of cold water for
15 minutes, avoid sunlight, uorescent light, and other ultraviolet light, and obtain immediate
medical attention. Eye wash facilities and a rst aid kit should be readily available and close to
the 3D printer system.
Contact Lenses
Wearing contact lenses is not recommended if handling liquid materials. If material splashes
into eyes when contact lenses are worn, ush eyes immediately with water. Verify that ushing
has removed the contact lens from the eye(s). Protect eyes from light and obtain immediate
medical attention. Discard contact lenses that come into contact with liquid material.
To Next Page
Loading...
