ProJet MJP 2500 - Page 5

8/10/22, 12:09 PM
Quick Start Guide
infocenter.3dsystems.com/projetmjp2500/print/book/export/html/861
5/44
Fume Inhalation
Under normal operation, inhalation is not an expected route of entry. Always work in a well
ventilated area when using materials and avoid breathing vapors. If inhaled, remove the
personalto fresh air. Give articial respiration or cardiopulmonary resuscitation (CPR) if
required. If breathing is dicult, give oxygen. Obtain immediate medical attention.
Ingestion
Uncured part material is toxic if ingested. Obtain immediate medical attention.
Hygienic Practices
Because uncured material is toxic if ingested, it must not be present where food and drink are
stored, prepared, or consumed. After handling materials, wash hands with soap and cold water
before consuming meals, breaks, smoking, applying cosmetics, using toilet facilities, and after
work.
Employees should be alerted of the need to clean and rinse off any contacted surface promptly
in order to prevent further contamination. Ensure a convenient washroom location is provided
with access to soap, water, and disposable paper towels.
Tools contaminated with part material should be cleaned prior to reuse. Solvents such as
denatured alcohol or Isopropyl Alcohol (IPA), are normally required to clean equipment and
tools. Wash with soap and water to remove any traces of excess part material or solvent.
Material Handling and Safety
Prior to using the ProJet® MJP 2500 & 2500 Plus users should be aware of potential
hazards which may result in exposure to uncured part material, such as removal of the
material waste bag and handling part material cartridges.
Emergency (GHS/SDS)
Chemtrec USA (800) 424-9300; Europe +1-703-527-3887
Consult the materials Global Harmonized Standards/Safety Data Sheets (GHS/SDS) for
information on specic materials. For further information on this and related topics, consult
the 3D Systems - Materials website at
http://www.3dsystems.com/support/materials/msds.

Packaging Inspection
The material cartridges are packaged in shipping cartons. Upon receipt of
materialshipments, inspect cardboard carton exterior for signs of damage and leakage.
Ifleakage is observed, DO NOT open carton, and contact 3D Systems’s TechnicalSupport