Storing a Partially Used Material Cartridge
It is important not to lay material cartridges that are partially used on their side. Doing so
will cause material to seep through the vent cap and clog cap. This will cause damage to
the material cartridge if used for a later print.To store a partially used Material Cartridge,
place it upright in a ProJet® MJP 2500 Cartridge Holder and tighten the vent cap.
Material Storage
Material should be stored in their original containers, according to the guidelines given in
the GHS/SDS included with the material. Protect material from sunlight and ambient room
light.
Never mix different materials.
Disposal
Disposal of fully cured parts are not subject to regulations of any known agency worldwide.
VisiJet® support material cartridges may be disposed of in ordinary oce trash.
Support Material
To Next Page
Loading...
