Proline GR800 - Advanced Remote Functions; Setting Fan Speed (Remote); Programming Timer for ON; Programming Timer for OFF

10
Settingthefanspeed(remotecontrolonly)
Repeatedlypress  toselectthefanspeed.
Thecorrespondingspeedindicatorwillbeshownontheremotedisplaytoindicatewhichspeedsettingisin
use.
InAUTO,cool( )andfanonly( )modes,youcanselectfromAUTOspeed,  lowspeed, 
middlespeedand  highspeed.

NOTE:
• When  isshownontheremotedisplayincoolmode,thefanspeedissamewith  highspeed.
• Iftheapplianceisindehumidification( )mode,youcannotselectthefanspeed.


Settingthetimer(remotecontrolonly)

ProgrammingthetimerforON–whentheapplianceisOFF. 
Press .Thetimeronindicatorwillflash. 

Repeatedlypressorholddown+/−tochangethetimeinhalfanhourincrementsupto10hours,and
thenin1hourincrementsupto24hours.
Press toconfirmandthetimeronindicatorwillstopflashing.Thetimerstarts.
Whenthesettimehasbeenreached,theappliancewillturnonautomatically.


ProgrammingthetimerforOFF–whentheapplianceisoperating.
Press .Thetimeroffindicatorwillilluminate. 

Repeatedlypressorholddown+/−tochangethetimeinhalfanhourincrementsupto24hours.
Press  toconfirmandthetimeroffindicatorwillstopflashing.Thetimerstarts.
Whenthesettimehasbeenreached,theappliancewillturnoffautomatically.


Tocancelthetimersetting
Press untilthetimeon/offindicatordisappearsontheremotedisplay.


Downloaded from www.vandenborre.be